Ismatec pumps and tubing
Ismatec Quality Pumps
Accessories for ISMATEC Pumps
Foot switch
Foot Switch
The foot switch serves as a start/stop device and can be connected to most Ismatec pumps.
Available for:
All Ismatec pumps featuring a digital input (TTL-level).
Cassettes
Cassettes (cartridges)
Most Ismatec multi-channel pumps use interchangeable cassettes as tube-bed.
Available for:
Multi-channel pumps
Tube connectors
Simple connectors, T-, Y, angle- and cross connectors
Adhesive for connections
Available for:
Tubing
Peristaltic pumps
Ergo_Adhesive
Adhesive for Ismatec pump tubing
- Adhesive for Tygon R3603 tubing
- egro® Adhesive for all tubing materials
Available for:
Tubing
Interchangeable rotor
Interchangeable Rotors
These interchangeable rotors are available with 2 or 3 rollers. 2 rollers provide a higher flow rate whereas 3 rollers reduce the pulsation.
Available for:
ECOLINE VC-280
ECOLINE VC-380
ProgEdit software
ProgEdit Software (free download)
This software enables the user to program individually definable dispensing and pumping sequences with a PC and to download the program to the memory of the pump drive. Up to 4 individual application programs can be stored in the MCP-Process which can run these programs independently as stand-alone system.
Available for:
MCP Process
MCP-Z Process
MCP-CPF Process
LabVIEW drivers (free download)

LabVIEW from National Instruments is an open environment designed to make interfacing with any measurement hardware simple.
LabVIEW delivers a powerful graphical development environment for signal acquisition, measurement analysis, and data presentation, giving you the flexibility of a programming language without the complexity of traditional development tools.


For the pump models listed, ISMATEC provides suitable drivers which can be downloaded for free.

Available for:

- MCP Process
-
MCP-Z Process
- MCP-CPF Process
- MCP Standard
- IPC / IPC-N
-
REGLO Digital
- REGLO Z Digital

 
IsmaTerm (free download)

IsmaTerm is an easy to use Terminal Program software. IsmaTerm can be used with all ISMATEC pumps featuring an RS232 interface. It is useful for testing the commands between PC and pump or monitoring the serial interface (with a second computer). Download IsmaTerm.zip (196 kB)

Available for:
All pumps with an RS232 serial interface

Last modified 13/08/15